Quick Answer

Yes, they need different beads. Concrete wire uses fast-cutting, medium-bond beads that handle steel and aggregate. Granite wire uses hard-bond beads with higher diamond concentration to cut tough, non-abrasive stone without shedding diamond too early.

Key Differences

Factor	Concrete Wire	Granite Wire
Bond	Medium	Hard
Beads / meter	30–40	28–32
Cutting style	Aggressive	Steady, controlled
Best for	Demolition, rebar	Quarrying, block cutting

How to Choose the Right Wire

• Demolition concrete with rebar → concrete wire with dense, tough beads.
• Granite quarry or block splitting → granite wire with hard-bond beads.
• Marble and soft stone → soft-bond wire that self-sharpens.
• Mixed jobs → change the wire per material instead of compromising.

How to Use It Correctly

• Keep water flowing to cool beads and remove slurry.
• Run the correct line speed for the wire spec.
• Inspect beads regularly; glazing means wrong bond, fast wear means too soft.
• Store wire coiled and dry to protect the rubber moulding.

Frequently Asked Questions

Q: Can I cut concrete with a granite wire?

A:It will wear quickly and cut slowly — concrete is abrasive and the hard bond dulls against it.

Q>Can I cut granite with a concrete wire?

A:Only for short jobs. The medium bond sheds diamond too fast on granite, so the wire wears out early.

Q: How long does a wire saw last?

A>It depends on material and feed. A matched wire on granite can cut hundreds of square meters; a mismatched one may fail in hours.

Conclusion

Match the bead bond to the material — never compromise. Use the Diamond Wire Saw for Concrete — JOY-WS-C for demolition and the Diamond Wire Saw for Granite — JOY-WS-G for granite block cutting.

Matching the Wire to the Job

Before ordering, confirm the dominant material: heavily reinforced demolition concrete behaves very differently from clean quarry granite, and a wire chosen for one will disappoint on the other. If a job mixes sections, plan the cut sequence rather than trying to compromise with a single wire. Keep water flowing at the correct volume, re-tension the wire as beads wear, and store spare coils dry so the rubber moulding does not crack. When bead wear looks uneven across the coil, the line speed or tension is usually the cause — worth discussing with the supplier before the next order.