Average response time: under 24 hours
Choose gang saw segments by material hardness, segment height, width, bond hardness and diamond concentration. Hard stone needs harder bonds and higher concentration; softer stone needs softer bonds. Always match the segment footprint to your blade's slot.
| Material | Bond | Concentration |
|---|---|---|
| Hard granite | Hard | High |
| Medium granite | Medium-hard | Medium-high |
| Marble | Soft | Medium |
| Sandstone / abrasive | Soft | Low-medium |
A:Diamond quality and concentration, plus segment size. High-concentration hard-stone segments cost more.
A:It varies widely — hours to days of cutting, depending on stone hardness and feed. Track square meters cut per set.
A:Used segments are usually replaced, not re-used. Matching sets cut evenly and keep the blade balanced.
Specify the segment for your material, machine slot and target output. The Diamond Segment for Multi-Blade Ganged Saw — JOY-MB-S serves multi-blade ganged saws, while the Quarry Blade Segment (Single Blade) — JOY-QB-S suits single-blade quarrying.
The most common ordering mistake is matching the segment height to the slot width and forgetting to check how the segment is welded or brazed on your particular blade body. Before reordering, measure a worn segment from your own line and note the stone mix you cut each week — bond recommendations change between single-material factories and mixed-material job shops. Keep water pressure and flow consistent across shifts, because a hot gang saw accelerates wear no matter how good the segment is. If wear pattern across segments is uneven, check blade alignment before blaming the consumable.
Written and reviewed by JOY TECH — an SGS & BV audited, CE/RoHS certified diamond tools manufacturer founded in 2004, exporting to 50+ countries.
Our factory and QMS are audited by SGS and Bureau Veritas. Products meet CE/RoHS requirements and every piece is 100% inspected before packing.
Verified Certificates
